No Water? We Answer the Phone.
Well Pump Repair in Granbury & Weatherford
No water, weak pressure, or a pump that won't shut off — same-day submersible and jet pump repair for homes and ranches across Hood and Parker County.
- Same-day service for no-water emergencies
- Submersible & jet pump diagnosis and repair
- Pressure switch, control box & pressure tank included
- TDLR-licensed pump work
Get a Free Quote
Tell us what's going on — we'll call you back fast.
No Water Today
Well Pump Repair When You Can't Wait
When a private well goes down, there's no backup — no water means no water anywhere in the house. Well pump repair is the call we get most, and we treat it that way: same-day response for no-water emergencies across Granbury, Weatherford, and the rural well country between them. Before you assume the pump itself has failed, though, a few quick checks can save you a service call — or tell us exactly where to start.
Check the Breaker
A tripped double-pole breaker is the single most common — and most harmless — cause of a well that suddenly has no water. Reset it once; if it trips again, stop and call us.
Don't Keep Cycling It
If power is fine and you still have no water, resist the urge to keep flipping switches or running fixtures. A submersible pump running dry can burn out its motor in minutes.
Call and Describe It
Tell us what you noticed — no water at all, weak pressure, a pump that won't stop running, clicking sounds, or tripped breakers. That detail helps us diagnose before we even arrive.
What We Diagnose
Submersible & Jet Pump Diagnosis and Repair
Most homes on the Trinity Aquifer in this area run submersible pumps set well down in the casing; some shallower setups use jet pumps. Either way, a "pump problem" is often not the pump at all — it's one of a handful of components that fail long before the pump motor does.
Pressure Switch
The switch that tells your pump when to turn on and off is a common failure point. A stuck or worn switch can cause no water, a pump that won't shut off, or wild pressure swings.
Control Box
Submersible pumps rely on a control box to start and run the motor. A failed capacitor or relay in the box can look exactly like a dead pump — the difference matters for cost and repair time.
Pressure Tank
A waterlogged bladder tank causes short-cycling — the pump kicking on and off rapidly — which wears out pumps and switches fast. See our pressure tank service page for more.
The Pump Itself
When the motor, impellers, or wiring have actually failed, we diagnose whether a repair makes sense or whether replacement is the better long-term move, and give you both options in writing.
Same-Day Service
Most No-Water Calls Are Fixable the Same Day
Pressure switches, control boxes, and pressure tank fixes are typically same-day repairs once we've diagnosed the problem on site. A full pump replacement can take longer depending on well depth and equipment availability, but you'll know which situation you're in — and what it costs — before any work starts. We don't leave a well-dependent household guessing overnight if we can help it.
Winter Storms
Freeze Failures Are a Recurring Problem Here
Winter storms are a real, recurring cause of well pump and system failures across Hood and Parker County. Exposed wellhead fittings, aboveground pipe, and pitless adapters can freeze and crack, and the cold snap itself can knock out a pressure switch or control box even when nothing physically froze. If your well went down during or right after a hard freeze, it's worth having the whole aboveground setup checked — not just the pump — so the same failure doesn't repeat next winter.
Running dry is the fastest way to kill a pump. If your well has stopped producing water — not just lost pressure, but gone completely dry — shut the pump off and call us before it runs unprotected. A submersible pump running with no water around it can overheat and fail within minutes.
Where We Work
Emergency Well Pump Repair Across Hood & Parker County
We respond to no-water calls throughout Granbury and the Lake Granbury communities and across Weatherford and rural Parker County, from in-town streets to acreage well off the highway.
Common Questions
Well Pump Repair Questions We Hear Often
My well suddenly has no water. What should I do first?
Check your breaker panel first — a tripped double-pole breaker is the most common harmless cause. If power is fine, don't keep cycling the pump; running a submersible pump dry can damage the motor. Call us at (817) 406-7679, describe what happened and what you've already checked, and we'll get a tech out. Most no-water calls trace to a failed pressure switch, a waterlogged pressure tank, or a worn pump.
How long does a well pump last?
Most submersible and jet pumps run 8–15 years, with some lasting 20 or more under good conditions. Heavy sediment, frequent short-cycling, or a pump that's been running dry can cut that life down to 5–6 years, which is why fixing the underlying cause matters as much as fixing the pump.
Can you fix my pump the same day?
Most pressure switch, control box, and pressure tank issues are same-day fixes once we're on site and have diagnosed the problem. A full pump pull-and-replace can sometimes take longer depending on well depth and parts availability, but we'll tell you which situation you're in before we start.
Why did my well pump fail during the winter storm?
Freeze events are a recurring cause of well failures in this area — exposed pipe, wellhead components, or aboveground fittings freeze and crack, and pressure switches and control boxes can fail from the cold snap itself. If your system went down during a hard freeze, it's worth having the whole aboveground setup checked, not just the pump.
No Water? Low Pressure? We Answer the Phone.
Same-day well service across Granbury, Weatherford & rural Hood and Parker County.